It’s once again Inspiration Friday at La-La Land Crafts. Our theme this week is to use products from the new release.
Courage Marci is prepared to fight like a girl! I am sending lots of hugs and hope her way.
I stamped this little sweetheart on X-Press It Blending Card and colored her with the following Copic Markers.
Skin: E04, E11, E00, E000, E0000, R20, R30, R00
Pinks: RV34, RV11, RV00, RV0000, R00, R000, R0000
Grays: W4, W2, W1, W0, W00
White Gel Pen
To create the outside ribbon border I die cut 4 of the Awareness Ribbon Die from pink cardstock. I place the die cuts upside down on a rotary mat used for quilting which has measurements on it so that I could make sure that it stayed square. I taped the pieces to the mat using Scotch removable tape so that I could glue the corners together. Once the glue was dry I could then remove the piece and glue it to my card.
I then die cut the scalloped square using the Scalloped Rectangles Die, partially cutting from both directions, moving the die over in order to create a square. The Double Stitched Squares Die was cut in the same way so that it fit the size of the opening.
I knew I wanted to create a shaker card with the Hope Heart Die, but needed the top of the heart to be a little bit thicker in order to add the double sided foam tape without it being visible. I knew if I matted the heart it would be just thick enough to make it work.
To create the matting around the heart I taped the Hope Heart Die onto a piece of pink cardstock and lightly traced around the outside and the inside with a fine point pencil and then carefully fussy cut it out by hand.
As always, there is an abundance of inspiration to be found in the store here.
Thank you so very much for stopping by!
Crafty Hugs – Pam xx
**I participate in La-La Land Crafts affiliate program. That means I receive a small commission when products are purchased through the links on my blog at no extra cost to you.
Thank you so much for your support!